P0132 Jeep Cherokee Error Code
When you get the P0132 error code on your engine’s monitor, there are a few things that could have caused it.
It may mean one or more of these:
The oxygen sensors in some cars can be faulty and send out this message when they’re too sensitive to changes happening around them; otherwise known as “shorting.”
The problem with Bank 1 is usually fixed by turning off your lights and staying stopped at intersections for about 10 minutes while waiting for traffic lights or just giving up hope!
If you’ve recently changed automotive parts like filters.
If you’re experiencing critical engine issues, it’s important to get an accurate diagnosis as soon as possible.
An oxygen sensor has failed and must be replaced!
An oxygen sensor failure caused damage to the harness running to it, which will eventually result in more expensive repairs if left unaddressed for too long.
What you need to know about this problem is that it could cause faulty data readings from your vehicle’s control module.
The issues you’re experiencing are all easily fixable by doing a little research and replacing the necessary parts.
Signs of P0132
One of the most frustrating things about a Code P0132 is that there’s no way to tell when it will happen or how long symptoms might last.
You could have an engine light and not even know why until later on down the road, so be sure your vehicle stays tuned up!
Some signs for codes include:
- The service engine light has been coming on for more than two weeks.
- The poor mileage per gallon is suspicious, and strange exhaust odors could be a sign of an impending issue with your car’s motor if it continues to get worse or does not improve over time despite changing filters!
What Are the Causes of Code P0132?
The code P0123 is a sign that there may be problems with your O2 sensors.
The most likely answer, though not always true in this case is exactly what you think it means; something went wrong with one or more of these devices and now they’re sending signals which indicate a problem but don’t necessarily mean anything else serious has occurred such as:
Those errors on startup isn’t just because someone turned off their car without shutting down properly either!
- When the O2 sensor goes bad or malfunctions, it will set your car’s computer off. The most common cause for this code is when a new sensor has been installed too soon after another one was damaged and then there are also some other factors that could lead to an error message like high voltage in certain areas where they shouldn’t be exposed too such as near air filters among others things so take care not just with replacing them but how often you have technicians work on our vehicles because every hour counts!
- Incorrect O2 sensors are installed – this can be a serious cause if not dealt with quickly.
- The wire harness that connects the gas sensor to your car’s system can be damaged by rust or other factors, which will cause readings from this device to appear wrong. You might not know it until after you’ve replaced all of them!
- The terminal where the sensors are attached is prone to corrosion.
Possible Solutions
Fortunately, you have a few options in this scenario.
Don’t get too worked up about it!
Replace the O2 Sensors
This may be the easiest and most common solution to your problem, but if you want something that is more involved than just replacing O2 sensors- we can help!
New types of sensors are available on Amazon for relatively inexpensive prices.
They will either fix bad ones or give off better readings depending on what was wrong with them in the first place.
Replace Broken Hardware
You don’t want to ignore the symptoms of damaged wires.
They may be costing you money!
If your Terminal is bad, it needs replacing and parts are available for less than $50 at an auto store or on Amazon
Conclusion
When the check engine light comes on, it’s usually because there is something wrong with one or more of your oxygen sensors.
This can be determined by examining them and making sure they’re not damaged before replacing any parts – which are cheap anyway!
If you want help doing this yourself though YouTube has plenty of detailed tutorials that will show exactly how to do everything from changing out lights to fixing major repairs like catalytic converters.
